Publicité
Installing and Removing Bits
Lock the variable-speed trigger switch "OFF"
by placing the direction-of-rotation selector in
the center position.
To install the bit:
Pull the locking sleeve forward, insert the bit
into the collet and release the locking sleeve to
lock the bit (Fig. 7a & 7b).
Pull the bit forward to check if it is locked.
To remove the bit:
Pull the locking sleeve forward (away from
the tool), pull the bit from the collet, and then
release the sleeve (Fig. 7c).
Use only bits with power grooves.
NOTICE
Other bits can be used with a
universal bit holder that has power groove. Do
not use bits that have a damaged shank.
WARNING
from the tool, or first allow the bit to cool
down . The bit may be hot after prolonged use.
14
Wear protective gloves
when removing the bit
Fig. 7a
Locking Sleeve
Collet
Fig. 7b
Fig. 7c
Publicité
