Publicité
Getting Started
Installation Requirements
■ The product is designed to be installed indoors and is for Household use only. Do not use your
coffee maker outdoors.
■ The product must be installed upright on a flat, level surface that is able to support the total
weight when full of water.
■ Install the product in a well-ventilated area with an ambient temperature between 55°F
and 90°F.
■ Do not place the product near heat sources such as ovens or cooktops.
■ Do not place the product in direct sunlight to prevent color fading.
■ Make sure the product cannot be accessed by children or animals.
Prepare Coffee Maker For Use
1. Carefully remove packing material. Do not use sharp tools that can damage the box contents.
2. Ensure all components are present. If any item is missing, please contact us at
GEAppliances.com.
3. Place the coffee maker upright on a flat, level surface. Make sure the coffee maker is
UNPLUGGED at this time.
4. Wipe the exterior with a warm cloth. Wash the mesh filter, brew basket, and carafe in warm,
soapy water with a soft cloth. Do not use abrasive cleansers, pads, or cloths, which can
scratch the surface. Rinse and dry thoroughly. Coffee maker parts are NOT dishwasher safe.
5. Plug the coffee maker into an electrical outlet. The clock will flash 12:00 AM when first
plugged in.
Inserting the Charcoal Water Filter
It is recommended to use a charcoal filter with the Profile Grind and Brew Coffee maker to remove
impurities and odors from your water. This helps your coffee maker perform at its best.
1. Carefully remove the charcoal water filter from the packaging and rinse with cold water.
NOTE: Rinsing the charcoal water filter with cold water before the first use helps remove loose
charcoal particles.
2. Remove the water reservoir from the base. See Figure: 1.
3. Unscrew the charcoal water filter Cartridge, located on the bottom of the water reservoir, by
rotating the winged cap counter-clockwise 90° with your hand. See Figure: 2
4. Place the charcoal water filter with the rounded bottom facing down into the charcoal water filter
cartridge. See Figure: 3.
5. Once the filter is in place, return the charcoal water filter cartridge to the bottom of the water
reservoir. Secure the cartridge using the winged cap by rotating the cap clockwise 90°.
DO NOT over tighten the cartridge. See Figure: 4
6. Place the water reservoir back into the base.
NOTE: It is recommended to change the charcoal water filter every two months or when Water
Filter appears on the display screen. This appears every 25 gallons brewed.
Reorder charcoal water filters from GEAppliances.com/ge/parts/. Have your model number ready.
6
49-9000061 Rev. 1
Publicité
