Functional Description; Technical Data; Before Use; Side Handle - Hilti DD 130 Mode D'emploi

4. Functional description

The DD 130 is an electrically powered diamond core
drilling machine designed for hand-held use or for mount-
ing on a drill stand. It is suitable for wet or dry core
drilling.

5. Technical data

Nominal voltage:
Nominal power:
Nominal current:
Frequency:
Nominal no-load speed 1
2
3
Max. permissible water supply pressure:
Dimensions (L×W×H):
Weight (basic tool):
Weight (drill stand):
Protection class:
Drilling depth:
Right of technical changes reserved

6. Before use

It is essential that the safety precautions printed in these
operating instructions are read and observed.
-CAUTION-
Disconnect the tool from the mains supply.
If extension cables are used: Only extension cables of a
type approved for the intended use and of adequate cross
section may be used. Failure to observe this point may
result in reduced performance and could cause the cable
to overheat. Damaged extension cables must be replaced.
The recommended cable cross-sections and maximum
lengths are:
Conductor cross-section
Mains voltage 1.5 mm
100 V
110–120 V 20 m
220–230 V 50 m
6
Printed: 08.07.2013 | Doc-Nr: PUB / 5069521 / 000 / 01
st gear
nd gear
rd gear
2 2.0 mm 2 2.5 mm 2 3.5 mm
20 m 40 m
40 m
80 m
Items supplied:
– Power tool

– Side handle

– Hilti toolbox or cardboard box
– Operating instructions
– Cleaning cloth
– Wrench SW 19
– Grease
– Protective glasses
110 V 120 V
1700 W 1800 W
16 A 15 A
50/60 Hz 50/60 Hz
780 /min
1400 /min
2600 /min
(Change gear only when rotation has stopped.)
6 bar (In the event of higher water pressure, a
pressure reduction valve must be fitted at the building
site connection.)
20.3×4.5×6.7" (515×114×170 mm)
approx. 15.7 lbs (7.1 kg)
approx. 28.9 lbs (13.1 kg)
Protection class I (earthed)
max. 16.9" (430 mm)
28.7" (730 mm) with extension
I The tool, the diamond core bit and the
drill stand are heavy.
I There is a risk of pinching parts of the
body.
I Wear a safety helmet, safety gloves and
safety boots.
6.1 Side handle
6.1.1 Fitting the side handle
1. Screw the side handle onto the tool and tighten it
2
securely.
6.1.2 Fitting the side handle in a different position
1. Remove the screw plug at the position where the side
handle is to be fitted (e.g. for left-handed use). The
-CAUTION-