Description; Technical Data; Safety Instructions - Hilti TE DRS-M Mode D'emploi

Location of identification data on the module
The type designation is shown on the appliance. Always
refer to this information when contacting our represent-
ative or service center.

2 Description

2.1 Use of the product as directed
The TE DRS‑M dust removal module is an accessory for
use with the Hilti TE 7, TE 7‑A, TE 7‑C, TE 6‑S and TE 6‑C
rotary hammers.
The dust removal module can be quickly and easily
attached to the power tool, i.e. the rotary hammer.
The dust removal module is not suitable for use when
chiseling or drilling in metals.
Please observe national regulations applicable to working
with materials hazardous to the health (e.g. asbestos).

3 Technical data

Right of technical changes reserved.
Appliance
Rated power input
Suction performance
Weight
Additional technical information
Operating stroke
Suitable TE‑C hammer drill bits (Ø)
Drill bit working length
Contact pressure
Dust container capacity
Suction head (Ø)
Dust container regeneration cycles

4 Safety instructions

WARNING! Read all instructions! Observe all applic-
able safety rules and the operating instructions for the
Hilti rotary hammer used. Failure to observe the instruc-
tions could lead to serious personal injury. SAVE THESE
INSTRUCTIONS
a) Modification of the machine or tampering with its
parts is not permissible.
b) Unplug the supply cord from the power outlet or, if
using a cordless tool, move the forward / reverse
switch to the middle position.
Type:
Serial no.:
The appliance is intended for professional use. The ap-
pliance may be operated, serviced and repaired only by
authorized, trained personnel. This personnel must be in-
formed of any special hazards that may be encountered.
The appliance and the power tool may present hazards
when used incorrectly by untrained personnel or when
used not as directed.
In order to avoid the risk of injury, use the appliance
only in conjunction with the Hilti rotary hammers named
above.
Accessories are available from your Hilti Center or can
be ordered online at www.hilti.com.
TE DRS-M
Max. 60 W
Max. 250 l/min
Max. 0.9 kg
Max. 105 mm
4...16 mm
50...100 mm
15...25 N
20 to 130 holes (depends on drill bit diameter and hole
depth)
4...16 mm
Up to 100
4.1 Dusts
This appliance collects a significant percentage, but not
all, of the dust generated.
Dust from materials, such as paint containing lead, some
wood species, concrete / masonry / stone containing
silica, and minerals as well as metal, may be harmful.
Contact with or inhalation of the dust may cause allergic
reactions and/or respiratory or other diseases to the op-
erator or bystanders. Certain kinds of dust are classified
en
7