Publicité
INDUCTION HOB
3) According to the heating zone where the pan is placed,
adjust heat setting by touching the slider regulating key
control.
•
If you don't choose a heat setting within 20 seconds,
the induction hob will automatically switch off. You will
need to start again at step 2.
•
You can modify the heat setting at any time during
cooking.
USING CHILD LOCK FUNCTION
•
You can lock the controls to prevent unintended use (for
example children accidentally turning the cooking zones
on).
•
When the controls are locked, all the controls except the
OFF control are disabled.
TO LOCK THE CONTROLS
Touch the child lock key for 3 seconds. The indicator above
the child lock key will be on and the timer indicator will
show "Lo".
TO UNLOCK THE CONTROLS
1) Make sure the hob is turned on.
2) Touch and hold the keylock control for a while.
3) You can now start using your induction hob.
NOTE
When the hob is in the lock mode, all the
controls are disable except OFF, you can
always turn the hob off with the OFF control
in an emergency, but you shall unlock the
hob first in the next operation.
USING THE TIMER
•
You can set it to turn one cooking zone off after the set
time is up.
•
You can set the timer for up to 99 minutes.
1) Select the relevant cooking zone which is working by
touching the zone select key.
2) Press the timer key, the timer indicators will show 30.
3) Using the " + " or " - " buttons, you can realize the setting
of timing from 1 to 99 minutes.
4) When the time is set, it will begin to count down
immediately. The indicator will return to show power
level after 10 seconds. The red dot next to power level
indicator will illuminate indicating that zone has set timer
.
5) If you need to check the remaining time, you can operate
step 1 and step 2 again.
Fig. 16
6) When cooking timer expires, the corresponding cooking
zone will be switch off automatically. Other cooking zone
will keep operating if they are turned on previously.
TO ENTER THE BRIDGE-HEATING FUNCTION MODE:
Press the bridge-heating button
to enter the bridge-heating mode. The display will show:
TO EXIT THE BRIDGE-HEATING FUNCTION MODE:
Press the bridge-heating button
again, to exit the bridge mode, and all the heating zones
will be reset to zero .
ADJUSTING THE HEATING LEVEL IN BRIDGE-
HEATING FUNCTION MODE:
To adjust the heating level under the bridge-heating
function:
1) In the bridge-heating mode, press the heating zone
selection button that needs to be adjusted. The two
heating zones in the bridge mode will flash and be
displayed simultaneously.
2) Adjust the power level as desired. Each burner will
display independently in its digital tube the current
heating level.
3) Wait 10 seconds to confirm the operation. It will be
flashing until the operation is successfully confirmed.
USING THE BOOSTER
1) You can use the booster function by pressing the
2) Touch booster key once, the display area will show p,
indicating that the hob has entered the booster mode.
&
at the same time
&
at the same time
key.
19
Publicité
