Parkside PDST 20 A1 Instructions D'utilisation Et Consignes De Sécurité page 10

3. Operation
Hold the hose 4 when unrolling and rol-
ling up so that the hose 4 cannot injure
anyone while swinging about.
Pay attention to the maximum working
pressure of the hose 4 . Only operate
the hose 4 within the given parameters
(see Technical data).
1. Slowly unroll the desired length of hose
through the hose guide 5 .
2. Plug the hose 4 into the compressor.
3. Connect the compressed air tool by
means of the fast coupling 3 .
4. Remove the tool from the hose 4 after
the work has been completed by pulling
the coupling 3 backwards hard.
Roll up the hose 4 again when the job is
done.
10 GB/IE/NI/CY/MT
5. Adjust holder
3 4
4. Maintenance, Cleaning and
Disconnect the hose reel from the compres-
sed air source before you begin to maintain it.
The holder 6 for the air hose reel is on the
back of the device. To apply the holder pull
the plastic downwards and to release pull
the plastic up again.
Storage
If the hose 4 is dirty, clean it before you
roll it up again. Never use aggressive
cleaning materials!
Regularly check that the hose 4 is airtight.
Regularly lubricate the moving parts of
the hose drum.
Immediately change defective and da-
maged parts.
When not in use, roll up the hose 4
completely and store it in a dry, clean
and frost-proof place.
6