Publicité
English
Always balance on both feet.
Do not lean on the machine.
If the blades encounter a foreign object (any object
except wood) or if the machine begins to make
abnormal noises and/or vibrates abnormally, stop
the engine to stop the blades from rotating. Take the
machine to a service center for repair.
If the machine jams, you must turn it off and wait for
the blades to stop rotating.
This machine is intended to be used outdoors only.
Also avoid working in open spaces where exhaust
fumes may accumulate.
The machine must be used by only one person,
preferably the same person.
Never put your hands into the input hopper until the
machine has been turned off and the blades have
stopped rotating.
Pieces of firewood that become stuck transversely
in the inlet hopper should only be removed when the
blades have stopped rotating.
Never leave the machine running or unattended. Stop
the engine and remove the spark plug cap before
replacing the blades or bed blade.
After one hour of operation, check that all screws and
nuts are tight,
If not, tighten them.
Always use original parts, otherwise the warranty will
become void.
The use of safety gloves,
ear protection and safety
glasses is mandatory.
38/116
The machine should only be repaired by an authorized
technical service.
6.4.2. ENGINE STARTING
Before starting the engine:
Be sure to check the oil level of the
engine and fuel tank and that the emergency button
is not activated. To deactivate the emergency button,
turn in the direction shown by the arrows on the
button itself.
6.4.2.1. COLD-STARTING THE ENGINE
A. Place the ON/OFF switch in the "ON" position.
B. Place the fuel tap in the open position.
C. Place the air lever in the Closed position
D. Place the accelerator lever in the maximum
position
.
E. Pull the starter grip until the engine starts up and
go past the air lever slowly to the OPEN position
(normal working position). Put the throttle lever
in the down position and let the engine warm for
.
Publicité
