Publicité
Supplied as standard
Part No.
2
3
4
5
6
7
Note: If a part is missing or damaged,
please contact the vendor.
Using for the first time
Screw the hand pump open
► P. 3, fig. 2
– Place the pump nozzle (5) onto the container (6).
– Screw the hand pump (2) onto the pump nozzle
(5).
Connecting the suction tube
► P. 3, fig. 3
– Insert the wider end of the suction tube (3) into the
pump nozzle (5).
Operation
Sucking in
► P. 3, fig. 4
– Push the connected suction tube (3) into the fluid
to be pumped.
– Hold the container (6) of the oil pump lower than
the fluid to be pumped.
– Pull the lever (1) upwards. Repeat the procedure
if necessary.
Troubleshooting
Fault
Pump power too low
Technical data
Part number
Container
Suction tube
Suction tube
Quantity
1
2
1
1
1
1
Cause
Product clogged
178399
1,6 l
130 cm
100 cm
Description
Hand pump
Suction tube 130 cm
Suction tube 100 cm
Suction lock
Pump nozzle
Container
Funnel
This causes the fluid to be sucked in. Due to the incli-
nation, the fluid automatically flows into the container
after being briefly sucked in.
Stopping
– Press the tube clip (4).
– or hold the oil pump container (6) higher than the
container of the desired fluid.
Cleaning
– Wipe the product with a dry cloth.
Storage
– Store the product in a frost-free place.
Disposal
CAREFUL! Avoid damage caused by leak-
ing fluids.
Do not dispose of the product with the household
waste! Proper disposal is mandatory. Information can
be obtained from the responsible waste disposal
facility.
Disposing of packaging
The packaging consists of cardboard and appropri-
ately marked films, which can be recycled.
– Take these materials to a recycling facility.
Remedy
Clean suction tubes
GB
11
Publicité
