Publicité
NOTICE! When enabling the weekly timer function, ensure
the workdays and time periods are properly configured. If no
configuration is set, the weekly timer defaults to 00 (i.e. inactive).
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
Wait until the rotating parts stop.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Do not spray the unit with a stream of water or immerse it in water.
d)
Make sure that no water enters through the ventilation openings in the casing.
e)
Clean the ventilation openings with a brush and compressed air.
f)
Use a soft, damp cloth for cleaning.
g)
Remove the battery from the appliance if you do not intend to use it for a long
time.
h)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
i)
Do not clean the device with acidic substances, medical products, thinners, fuel,
oil or other chemicals as this may damage the device.
j)
In case the device does not fully respond to the remote control, check the
condition of the battery and, if necessary, replace it with a new, functional one.
To replace the batteries of the remote control, press the latch of the battery
compartment (at the bottom of the remote control at its back) and pull out the
compartment with the battery. When replacing the battery, pay attention to
the correct polarity according to the diagram on the back of the remote control
housing.
EN
Publicité
