Appliance Description; Before Taking Into Use; Charging The Batteries - SilverCrest SHBS 1000 A1 Mode D'emploi

Appliance description

Figure A:
Cutting set with titanium-coated trimmer block and ceramic trimmer blade
Slide switch for cut length fi ne adjustment 0.5 mm / 1 mm / 1.5 mm /
2
2.0 mm / 2.5 mm
3
On / off switch
Charging indicator lamp
4
Charging station / holder with connecting socket for power supply unit
5
Figure B:
Power supply unit
6
Figure C:
Cut length add-ons 4 - 6 mm / 7 - 9 mm / 10 - 12 mm / 16 - 18 mm /
7
22 - 24 mm / 28 - 30 mm
Thinner add-on
8

Before taking into use

The hair and beard trimmer can be used as a battery-powered or mains-powered
appliance.

Charging the batteries

The batteries for the hair and beard trimmer should be charged for at least 3 hours
before fi rst use. A charging time of 60 minutes is suffi cient for all further charges.
Ensure that the appliance is completely charged before you use it without the
power supply unit
and overload protection so that the batteries can be recharged without the
danger of overcharging.
♦ Connect the power supply unit cable
station
♦ Avoid damaging the appliance! Ensure that the appliance is switched off before
charging the batteries.
♦ Plug the power supply unit
socket complying with the appliance specifi cations.
♦ The charging process is displayed using a continuous bar and increasing minute
display in the charging display
once the bar in the charging display
displayed.
♦ Once the batteries are completely recharged, you can use the appliance for
around 60 minutes without connecting it to the power supply.
SHBS 1000 A1
. The appliance is fi tted with 2 NiMH rechargeable batteries
6
.
5
(wide voltage range 100 - 240 V) in a power
6
to the hair and beard trimmer charging
6
. The batteries have been completely charged
4
no longer fl ashes and 60 minutes is
4
GB
49