Publicité
\I
match arrows
with tabs on
clear hose inlet
HOSE
ASSEMBLY AND TOOL STORAGE
1. ATTACH HOSE: Attach the flexible hose to the cleaner (Diagram 1). Match the arrows on the hose to the tabs on the clear hose inlet
(Diagram la). Push down firmly on the cuff and tprn clockwise. Insert the hose handle into the side of the cleaner. Press down firmly to
secure (Diagram 2).
2. ATTACH TOOLS: (Diagram 3) (A) Slide Edge WedgeTM onto the base of upper handle with bristles facing in. (B) Slide 2-in-1 tool onto
upper back panel with bristles facing out. (C) Slide the Telescopic wand, small end down, onto the lower back panel. (D) Slip crevice tool
onto lower back panel.
3. CORD STORAGE: For tidy cord storage, wrap cord around hooks on side of cleaner (Diagram 4) (A).
HOW TO OPERATE
I. Plug cord into electrical outlet. 2. Turn cleaner "on". Switch located on left side of cleaner directly
above HEPA filter (Dia ram 1
.
3.
Release handle by de ressing pedal (Diagram 2) 4. Select brush roll "on" or "off (Diagram 3).
FLoowcARPET cLihNlNd
-
TURN BRUSH ROLL
OR
--
-
-
.
- -
-~
1. Use the window on the nozzleto see if the brush roll is moving.
2. As you switch to different carpet piles, move the height adjust knob to match the surface being cleaned (Diagram 3).
3. The edge bristles (Diagram 4), provide effective baseboard cleaning.
4. Depressing handle release a second time while in use will lower cleaner to lie flat, allowing to clean under furniture.
NOTE: Rotatina brush could cause area rua frinae to become tanaled within cleaner. Use caution when vacuuming throw rugs with fringe.
DIRT
SENSORITM
SYSTEM
-
SIGNALS
YIOU
WHEN CARPET
IS
CLEAN (DIAGRAM 5)
The Dirt Sensor System uses sound and vibration to detect existing dirt. Light particles such as dust won't be detected. Embedded dirt
will then be detected while vacuuming.
Red lights indicate dirt is still being picked up.
Green lights indicate that carpet is clean.
NOTE: Correct height adjustment should be selected for the Dirt Sensor to function properly.
BAREFLOOR AND ABOVE FLOOR CLEANING
-
TURN BRUSH ROLL OFF
1. Turn brush roll off. NOTE: Cleaner must be "on" when activating/deactivating brush roll.
2. Continue to vacuum barefloors and rugs or use attachments for above floor cleaning.
3. TO USE ATTACHMENTS (Diagram 6).
Remove the hose from the side of the cleaner using the handle (Diagram 5).
Choose any of the handy accessories or use the hose alone. Simply push the attachment firmly onto the end of the wand or hose
handle. To remove tool, twist and pull apart gently.
If additional length is needed use the telescopic wand (See page 6).
A threshold stop is incorporated into the cleaner which enables it to be transported from barefloor to carpet by lowering the handle
back until the nozzle is lifted off of the floor.
*Not available
on
all models.
5
Publicité
