Continuity Test; Battery Test - VOLTCRAFT VC2030A Notice D'emploi

f) Continuity Test
Make sure that all circuit parts, circuits and components and other objects of
measurement are disconnected from the voltage and discharged.
• Connect the black measuring line to the COM socket "8" and
the red one to the socket V, Ω,
• Set the adjustment wheel "4" to the area
"5" to "DC, , Ω"
• Connect the two measuring prods with the object to be
measured
• A resistance value up to 40 Ohm will cause a signal to sound
g) Battery Test
• In order to test the capacity of a battery, connect the black measurement line to the COM
plug "8" and the red line to the plug "V, Ω."
• Set adjustment wheel "4" according to the battery type, to
1.5 v. or 9 v., and switch "5" to "DC".
• Place the red measuring tip on the plus pole and the
black measuring tip on the minus pole of the battery.
• The currently measured capacity can be read on the
scale display under the following values
BAT
REPLACE
GODD
36
, "7".
, and the slider
The battery is defective
The battery should be exchanged soon
The battery has adequate reserves
DC
V
AC
DC
AC
DC
V
AC
DC
AC