Resistance Measuring - VOLTCRAFT VC2030A Notice D'emploi

e) Resistance Measuring
Make sure that all circuit parts, circuits and components and other objects of
measurement are disconnected from the voltage and discharged.
Connect the black measuring line to the COM socket "8" and
the red one to the socket V, Ω,
• Set the adjustment wheel "4" to the area Ω and the slider "5"
to "DC, , Ω"
• Connect the two measuring tips. A reading of 0 ohm should
then be displayed. If not, adjust the display with the 0 ohm
tuning controller (6) at exactly 0 ohm.
If this is not possible, change the batteries (AA).
• Connect the two measuring prods with the object to be measured.
• The measuring value is shown on the analogue scale "1". Take the value and multiply it with
the values of the following table:
Ohm-range
X 1
X 10
X 100
X 1K
"7".
Multiplication factor
X 1
X 10
X 100
X 1000
DC
V
AC
DC
AC
35