Hendi 225479 Mode D'emploi page 8

Step 4
• Lay the appliance sideway on the
other side
• Reassemble the door
Faults and Error Codes:
Fault
Appliance does not work
EN
Appliance does not reach the set
temperature
When the temperature sensors or the temperature
in the oven is not functioning correctly, the digi-
Error Code
501
502
In case of any doubt, always contact your supplier!
8
• Reinstall the hinge
• Position the oven in horizontal
position and reconnect the power
supply
Possible cause
No power at the electrical outlet
Green on/off switch on the backside
(if present) is not turned on
The plug is not plugged (correctly)
into the electrical outlet
Heating element defective
Control unit defective
Heating element fuse defective
Possible Fault(s)
chamber temperature sensor (NTC) is
shortened or open
chamber temperature higher than 152ºC or
lower than -30ºC
Food core temperature sensor (NTC) is
shortened or open
Food core temperature higher than 158ºC
or lower than -15ºC
Step 5
Possible solution
Check the fuse
Turn on the on/off switch on the back
(if present)
Check the plug
Contact the supplier
Contact the supplier
Contact the supplier
tal display D1 may show one of the following error
codes.
Possible solution
Contact the supplier
Wait until the chamber temperature restores to
normal
Contact the supplier
Wait until the food core temperature restores to
normal