Hendi 225479 Mode D'emploi page 4

Preparations before using for the first time
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance with luke-warm water and a
soft cloth.
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
Control Panel
K1 L1
Green ON/OFF switch at the backside (if present)
K1 Standby button
K2 Selection Button
K3 Adjustment Button – Decreasing
EN
K4 Adjustment Button – Increasing
K5 Start / Pause Button
D1 Digital Display
L1 Power Indicator light
L2 Chamber temperature Indicator light
L3 Internal core temperature Indicator light
L4 Timer Indicator light
L5 Hold temperature Indicator light
L6 Operation Indicator light
Start
Connect the plug to the power socket and the press
the green ON/OFF switch at the backside if present.
Press the standby button (K1).
4
D1 L2 L3
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
• Heat the appliance without food for about an hour
at the highest temperature.
➯ Follow always the HACCP regulations.
L4 L5 K2
• The oven will beep one time and then all indicator
lights, L1 to L5, and display D1 will be ON for 0.5
second. After that, indicator light L1 is ON to show
that the oven is ready for operation (in standby
mode).
K3 K4 L6 K5