Publicité
The following is a list of faults that the user can quickly remedy after following the described solution.
Call the service division if another fault is displayed, or the defect cannot be fixed.
Troubleshooting table
Problem
The dish remains cold.
The dish isn't warm enough.
The control lamp flashes
regularly (with the drawer
closed).
The control lamp flashes rapidly
(with the drawer opened).
The control lamp does not
illuminate when the drawer is in
operation.
The control lamp flashes rapidly
(with the drawer openend or
closed).
The operating panel shows no
reaction when touched.
The drawer cannot be
opened/closed.
Possible cause
The appliance is not switched
on.
An interruption in the power
supply.
The drawer is not closed
properly.
Warming duration too short.
Temperature is not set high
enough.
The delayed start is activated.
The delayed start is activated.
Control lamp is defective.
The Sabbath mode is activated.
Drawer is still in operation.
The Sabbath mode is activated.
The control panel is defective.
Push-pull mechanism is
defective.
Troubleshooting
Solution
Switch the appliance on.
Replace the fuse or switch on
the fuse again in the fuse box.
Close the drawer.
Lengthen the warming duration.
Select a higher temperature
setting.
Deactivate delayed start mode.
Close the drawer and then
select operation with a delayed
start. Touch the on/off-key to
end the delayed start.
Contact the service department.
Deactivate Sabbath mode.
Touch the on/off-key.
Deactivate Sabbath mode.
Contact the service department.
Contact the service department.
21
Publicité
