Publicité
GB
Starting the motor
DANGER! Danger of fire! Spilled
fuel can set the product on fire.
Carefully wipe up any spilled fuel up
before starting.
Start the product a minimum of nine
metres away from where you filled it.
Note: In case of start-up difficulties,
please refer to the following able:
► Troubleshooting – p. 52
► P. 3, item 1
► P. 3, item 2
– Press the switch-on lever (1).
– Slightly press fuel pump (12) approx. 3×.
– Slow pull out the pull starter (9) until you
feel a resistance, then quickly and force-
fully, until the initial ignition noise can be
heard.
– Pull out the pull starter again quickly and
forcefully until the motor starts up.
Switching off the motor
WARNING! Risk of injury! Always
switch off the product when not in use
for short periods.
► P. 3, item 1
– Release the switch-on lever (1).
Mowing
DANGER! Risk of injury! Before
beginning work, check the terrain and
remove all objects that may be flung
out by the product.
– Steer the product at an even, slow speed
(walking pace) in the straightest lines pos-
sible.
Important notes
• Always work across slopes where possi-
ble.
• Do not cut wet grass if possible.
• Overlap the mowing lines slightly for an
even appearance.
• Cut long grass first at the greatest possi-
ble cutting height, then mow in transverse
direction at the desired cutting height.
► P. 7, item 10
• If the air flap (30) closes, the collection
container is full and must be emptied.
50
All manuals and user guides at all-guides.com
Information on mulching
Note: Mulching is the use of cut grass
as a natural compost. When mulch-
mowing, the grass is cut, finely
chopped and spread across the grass
in one operation.
► Mounting the mulch wedge – p. 49
• Do not mulch moist grass.
• Regularly clean the mulch wedge, ejec-
tion channel and cutting blade.
Cleaning and maintenance
DANGER! Risk of injury! Perform
only the maintenance work described
here yourself.
Improper work can cause product
damage and hence physical injury.
DANGER! Risk of injury! Before
any maintenance and/or cleaning
work:
– Switch off the product.
– Close the fuel valve.
– Turn off the ignition switch.
– Allow the product to cool down.
Cleaning and maintenance at a glance
Before each use
What?
General function
check.
Check and, if nec-
essary tighten, all
screw connec-
tions.
Check cable of the
pull-starter for
damage
Check motor oil
level
After each use
What?
Cleaning the prod-
uct
Every 25 hours of operation
What?
Cleaning the spark
plug
Replacing the air
filter
How?
Visual inspection.
Hand-tighten the screw
connections using the
appropriate tool.
Visual inspection.
► Checking the motor
oil level – p. 51
How?
► Cleaning the pro-
duct – p. 51
How?
► Cleaning the spark
plug – p. 51
► Replacing the air fil-
ter – p. 51
Publicité
