Publicité
GB
• Operating the machine at excess speed
can increase the risk of accident.
• When turning on the machine, make sure
that your fingers are not caught between
the moving cutting blades and fixed parts
of the machine.
Maintenance and storage
• Make sure that all nuts, bolts and screws
are firmly tightened. You will then know
that the product is in a safe working con-
dition.
• While petrol is in the tank, never store the
lawnmower in a building in which petrol
vapours may come into contact with
naked flames or sparks or can be easily
ignited.
• To avoid the risk of fire keep the motor,
exhaust, and petrol tank area away from
grass, leaves, and leaking grease (oil).
• Regularly check the grass catcher for
wear or loss of functionality.
• Let the motor cool before turning off the
machine.
• When maintaining the cutting blades,
please note that the cutting blades can be
moved even when the machine is
switched off.
• For safety reasons always replace worn
or damaged parts. Use only original spare
parts and accessories.
• Should the tank need draining, do so out-
doors using a petrol suction pump.
Your product at a glance
Note: The actual appearance of your
product may differ from the illustra-
tions.
► P. 3, item 1
1. Switch-on lever
2. Handlebar
3. Handlebar, bottom part
4. Safety flap
5. Motor
6. Ejection opening
7. Lever for cutting height adjustment
8. Collection box in construction
9. Pull-starter
► P. 3, item 2
10. Motor oil filling screw
11. Tank cover
12. Fuel pump
13. Air filter housing
48
All manuals and user guides at all-guides.com
14. Ignition cable with spark plug
Scope of supply
• Instructions for use
• Lawn mower
• Collection box
• Mulch wedge
• Handlebar
• Handlebar, bottom part
• Bag containing small parts
Assembly
Mounting the handlebar
Note: All mounting steps must be
performed on both sides.
► P. 4, item 3
– Insert the form screws (15) through the
boreholes in the bottom part of the han-
dlebar.
– Turn the stop bolt (16) as shown so that
they are inserted.
– Place the bottom part of the handlebar (3)
on the machine as shown in such a way
that the pull starter holder (17) is on the
right side.
► P. 4, item 4
– Insert the hexagon nuts (18) and tog-
gles (19) into each other as shown.
– Position the assembled toggle nuts (20)
and tighten them.
– Turn the stop bolts (16) by 90° again and
engage them in boreholes (21).
► P. 5, item 5
– Insert the cross nut bolts (22) and clamp-
ing levers (23) into each other as shown.
– Position the handlebar (2) onto the bot-
tom part of the handlebar (3) and push
through the carriage bolts (24).
– Put the washers (25) on.
– Put the assemble clamping lever (26) into
place and tighten it slightly in a clockwise
direction.
– Press the clamping lever (26) towards the
handlebar.
– If the clamping lever does not safely
clamp: open the clamping lever again in a
clockwise direction and tighten it to the
limit stop.
– If the clamping lever cannot be tightened
to the limit stop: open the clamping lever,
make a counter-clockwise revolution, and
tighten it to the limit stop.
Publicité
