CONSTRUCTA CM321052 Manuel D'utilisation Et Notice D'installation page 24

en Installation instructions
9.4 Installing the hob
Ensure that the cables are not trapped or pinched, and
do not route them over sharp edges.
¡ The hob can also be installed in an existing cut-out
that has a depth of 500 mm.
¡ It must protrude by the same distance at the front
and the rear.
9.5 Removing the hob
Disconnect the appliance from the power supply.
1.
Slide the cooker out and place it in front of the unit
2.
(and on a pedestal, if required).
Unplug the hotplate plug.
3.
Finally, disconnect the PE conductor (green/yellow)
4.
from the earthing screw.
Push out the hob from below.
5.
24