The contact details for Customer Service can be found
in the enclosed Customer Service directory or on our
website.
8.1 Product number (E-Nr.) and production
number (FD)
You can find the product number (E-Nr.) and the pro-
duction number (FD) on the appliance's rating plate.
The rating plate can be found:
¡ on the appliance certificate.
9 Installation instructions
Observe this information when installing the appliance.
9.1 Safe installation
Follow these safety instructions when in-
stalling the appliance.
¡ Electrical connection must only be carried
out by licensed specialist staff. Incorrect
connection will invalidate the warranty.
9.2 Preparing the units
The worktop must be level, horizontal and stable.
¡ The fitted units, including wall finishing strips, must
be heat-resistant to at least 90 °C.
¡ Niche cladding within 50 mm of the back wall must
not be combustible (e.g. tiles, stone).
9.3 Connecting the hob
Requirement: The cooker must be connected to the
mains, but switched off.
Screw the PE conductor (green/yellow) for the hob
1.
to the cooker's earthing point .
¡ on the lower section of the hob.
Make a note of your appliance's details and the Cus-
tomer Service telephone number to find them again
quickly.
¡ The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for any damage resul-
ting from incorrect installation.
¡ The hob and cooker must be from the sa-
me brand, and have the same combination
feature.
¡ Contact protection must be guaranteed by
the installation.
¡ Observe the installation instructions for the
cooker.
¡ With an appropriate substructure
to 16 mm can also be used.
¡ Seal the cut surfaces to make them heat-resistant.
This prevents the worktop from swelling as a result
of moisture.
Plug the hotplate plug into the cooker.
2.
The colour of the cable should match the colour
shown on the label.
Installation instructions en
, worktops
up
23