HP Photosmart C4500 All-in-One Série Guide D'utilisation page 14

Chapter 1
To restore network defaults
1. Press the Wireless button on the product.
2. Press the button next to the down arrow on the display until Restore Network
Defaults is highlighted, and then press OK.
3. Confirm that you want to restore the network defaults.
Turn the wireless radio on and off
The wireless radio is off by default, but when you install the software and connect the
HP All-in-One to the network, the wireless radio is turned on automatically. The blue light
on the front of the HP All-in-One indicates that the wireless radio is on. In order to stay
connected to a wireless network, the radio must stay on. However, if the HP All-in-One
is connected directly to a computer with a USB connection, the radio is not used. In this
case you might want to turn the radio off.
To turn the wireless radio on and off
1. Press the Wireless button on the product.
2. Press the button next to the down arrow on the display until Turn Radio On or Turn
Radio Off is highlighted, and then press OK.
Print the wireless network test
The wireless network test performs a series of diagnostic tests to determine whether
network setup is successful. If an issue is detected, a recommendation on how to correct
the issue will be included on the printed report. You can print the wireless network test at
any time.
To print the wireless test report
1. Press the Wireless button on the product.
2. Press the button next to the down arrow on the display until Wireless Network
Test is highlighted, and then press OK.
The Wireless Network Test prints.
10 HP Photosmart C4500 All-in-One series