Publicité
26 | English
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and accessories, keeping their hands warm, and
organising workflows correctly.
Kickback control
If there is a sudden kickback in the power tool,
e.g. jamming in a separating cut, the power
supply to the motor will be interrupted elec-
tronically.
To restart the tool, set the On/Off switch (3) to
the "off" position and then switch the power tool on again.
Restart protection
The restart protection feature prevents the
power tool from uncontrolled starting after the
power supply to it has been interrupted.
RESTART
PROTECTION
Speed preselection
(GWS 18V-11 S)
You can preselect the required speed using the speed preselection thumbwheel (4), even during operation. The information in
the table below describes the recommended values.
Material
Application
Metal
Removing paint
Metal
Brushing, removing rust
Stainless steel
Grinding
Metal
Rough grinding
Metal
Cutting
Stone
Cutting
The rated speed of the accessory must be at least
u
equal to the maximum speed marked on the power
tool. Accessories running faster than their rated speed
can break and fly apart.
Level
GWS 18V-11 S
Speed preselection
[min
1
3000
2
4500
3
5400
4
6200
5
7000
6
9000
The values specified for speed levels are guide values.
Rechargeable battery
Bosch sells some cordless power tools without a re-
chargeable battery. You can tell whether a rechargeable bat-
1 609 92A 9PG | (07.08.2024)
To restart the tool, set the on/off switch (3) to the off posi-
tion and then switch the power tool on again.
Run-out brake
INTELLIGENT
BRAKE SYSTEM
Drop control
The integrated drop control switches the power tool off as
soon as it hits the floor. To restart the tool, set the On/Off
switch (3) to the "off" position and then switch the power
tool on again.
Data logging
Application tool
Sanding sheet
Cup brush, abrasive disc
Grinding disc/fibre disc
Grinding disc
Cutting disc
Diamond cutting disc
tery is included with the power tool by looking at the pack-
aging.
Charging the battery
u
-1
]
Note: Lithium-ion rechargeable batteries are supplied par-
tially charged according to international transport regula-
tions. To ensure full rechargeable battery capacity, fully
charge the rechargeable battery before using your tool for
the first time.
Inserting the Battery
Push the charged battery into the battery holder until it
clicks into place.
The power tool is fitted with an electronic run-
out brake. When the power tool is switched off
or the power supply is interrupted, the abras-
ive tool is brought to a complete stop within a
few seconds.
Tool data logging is enabled in this tool.
Thumbwheel position
2–3
3
4–6
6
6
6
Use only the chargers listed in the technical data. Only
these chargers are matched to the lithium-ion battery of
your power tool.
Bosch Power Tools
Publicité
