Publicité
Connection to the control panels. C
⚠ Always connect the LAMP terminal to the W-E1 terminals on the
230 V panels C ⑪ or the 10-E input of the RIOCT8WS to terminals
10-E or 10-E1 of the 24 V control panels C ⑫.
☞ Always enable the pre-flashing.
☞ Enable the services test (if present).
☞ Generally avoid those conditions in which when the operator is idle
the flashing light is active.
For example, with function C4 enabled on the CAME panel, if the
photocell is engaged, the RIO accessories shall remain active for the
entire intervention period, thus reducing battery life.
RESETTING procedure
Keep the RESET button pressed for 10 seconds, until the WIRELESS LEDs
start flashing.
N.B.: If you replace any device on the system, you will have to
RESET and then again SAVE all of the system devices.
Functional checks
Issue a start command (each RIO accessory will flash * blue)
Make sure that the RIOLX8WS activates.
Obstruct the gate's action and check whether the RIOPH8WS and/or
RIOED8WS devices actually activate the prescribed safety function.
When the maneuver is complete, each RIO accessory will flash* red and
switch into LOW POWER mode to preserve the batteries.
⚠ In LOW POWER mode, the photocells will respond more slowly - the
LED flashes blue - to the manual operation test.
* If this does not happen, cut off the mains power supply and increase
the radio signal's range/power by setting the jumper E ⑤ to position H.
FA01695M4A - 06/2024
FA01695M4A - 06/2024
WIRELESS
WIRELESS
WIRELESS
WIRELESS
WIRELESS
WIRELESS
WIRELESS
WIRELESS
CH1
CH1
CH1
CH1
CH1
CH1
CH1
CH1
CH2
CH2
CH2
CH2
CH2
CH2
CH2
CH2
WIRELESS
WIRELESS
WIRELESS
WIRELESS
CH1
CH1
CH1
CH1
CH2
CH2
CH2
CH2
Troubleshooting
Alerts
Possible causes
TS terminal (safety test)
WIRELESS
WIRELESS
WIRELESS
not connected.
CH1
CH1
CH1
CH2
CH2
CH2
No Rio accessory is
WIRELESS
WIRELESS
WIRELESS
WIRELESS
memorized.
CH1
CH1
CH1
CH1
CH2
CH2
CH2
CH2
The photocells:
WIRELESS
WIRELESS
WIRELESS
WIRELESS
WIRELESS
WIRELESS
a. detect an
CH1
CH1
CH1
CH1
CH1
CH1
obstruction;
CH2
CH2
CH2
CH2
CH2
CH2
b. are misaligned;
c. have flat batteries.
The sensitive
WIRELESS
WIRELESS
WIRELESS
WIRELESS
WIRELESS
WIRELESS
safety-edge does not
CH1
CH1
CH1
CH1
CH1
CH1
intervene.
CH2
CH2
CH2
CH2
CH2
CH2
LED stays on,
Fix
Connect the TS terminal
WIRELESS
WIRELESS
WIRELESS
(or 2, is missing) to the
CH1
CH1
CH1
corresponding one on the
CH2
CH2
CH2
control panel.
Configure RIO
WIRELESS
WIRELESS
WIRELESS
accessories.
CH1
CH1
CH1
CH2
CH2
CH2
a. Remove the
obstruction.
b. Align the photocells.
c. Replace the batteries.
Check settings and
WIRELESS
WIRELESS
WIRELESS
WIRELESS
adjustments on the
CH1
CH1
CH1
CH1
sensitive safety-edge.
CH2
CH2
CH2
CH2
LED is off,
LED flashes
Buzzer active
WIRELESS
CH1
CH2
Publicité
