Publicité
• Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water.
If liquid contacts eyes, additionally seek med-
ical help. Liquid ejected from the battery may
cause irritation or burns.
Additional safety notes
• Prior to starting work, use appropriate tool to
determine whether there are any hidden sup-
ply lines are located on the area you are work-
ing in. If in doubt, ask the relevant supply ser-
vices. Contact with power lines may cause fire
and electrical shock. Damaging a gas pipe may
cause an explosion. Damaging a water pipe
leads to considerable property damage and may
cause electrical shock.
• Immediately switch off the power tool when it
becomes blocked. Be prepared for sudden
forces occurring which may cause kickback.
The insert tool blocks, for example, due to over-
loading or tilting.
• Hold the power tool firmly. When tightening
and undoing screws, high forces may occur for a
short time.
• Secure the work piece. Use tensioning equip-
ment or a vice to secure the work piece to help
prevent kickback or uncontrolled flying of the
work piece (e.g. when getting jammed in the work
piece).
• Never set the power tool down before the tool
has come to a completed standstill. The
rotating tool may come into contact with the sur-
face and cause you to loose control over the
power tool.
• Do not open the battery. The battery may be
damaged as a result of improper actions.
• Do not expose the battery to heat, fire, water
and damp. There is a risk of explosion.
• In the event of damage or incorrect use of the
battery, vapours may escape. Make sure that
the ventilation is good and, if you have any
medical complaints, consult a doctor. These
vapours may irritate the air passages and cause
illness.
• Never attempt to recharge batteries that are
not designated rechargeable. There is a risk of
fire and explosion.
• The battery may only be used in conjunction
with this power tool. Other power tools may
overload the battery and thus damage it.
• Only batteries authorised by the manufac-
turer with the values listed on the type plate
of this power tool may be used. The use of a
different battery may cause a risk of injuries and
property damage as a result of an exploding bat-
tery.
• Only chargers authorised by the manufac-
turer with the values listed on the type plate
of this battery may be used. The use of a dif-
ferent charger may cause a risk of injuries and
property damage as a result of an exploding bat-
tery.
• Symbols affixed to your unit may not be removed
or covered. Information on the unit that is no
longer legible must be replaced immediately.
• Do not modify the battery
• In case of battery leakage, please avoid contact to
skin and eye. If contact accidentally, do not wash
the affected area with water (as there might occur
chemical reaction) and seek medical advice.
Unpacking and installation
Unpacking
– Unpack the unit and make sure all of the pieces
are there.
Scope of delivery
► Scope of delivery – p. 3
1. Awning
2. Hex key
3. Fixing bracket (2×/3×*)
4. Hand crank
5. Radio remote control with wall mount
6. Battery charger
• Bag containing installation materials:
– Wall anchors (8×/12×*)
– Nuts (8×/12×*)
– Spring washers (8×/12×*)
– Washers (8×/12×*)
• Operating instructions
*)
only for 647310
Description of awning parts
► Overview – p. 4
1. End caps
2. Cassette
3. Motor (built-in)
4. Arm supports
5. Awning cloth
6. Front cover
7. Hinged arm
8. Fixing bracket
9. Battery (built-in)
10. Solar cell
Remote control
11. [
] button
12. [
] button
13. [
] button
14. [P2] button
15. Wall bracket
16. Battery
Installation
► Assembly – p. 5
GB
41
Publicité
