Publicité
Do not use hard brushes, steel wool, abrasives (such as toothpaste), organic solvents (such as alcohol, acetone, oil, etc.),
boiling water, acid or alkaline product to clean the appliance, as this could damage the surface and interior of the appliance.
Boiling water and benzene could deform or damage plastic components.
REPLACING THE LED LAMP
This appliance has been provided with a LED lamp. This lamp lasts for a longer period of time. When the LED lamp in the
appliance is broken, you are not able to replace it yourself. Contact the Tomado service department.
Failure
The thermostat knob is on [0].
The appliance
no longer works
The plug is not in the socket.
Wrong setting of the thermostat.
The door of the appliance is opened too
frequently or remains open for too long.
A large amount of warm food has been
Temperature in the
placed in the appliance in the last 24 hours.
appliance is too high
The ambient temperature is higher or lower
or too low
than the temperature indicated in the table
with technical data.
The appliance is located in direct sunlight
or near a heat source.
There is water in the
The opening of the defrost water drain
lower section of the
is clogged.
appliance.
The interior lighting
The door has been open for too long
flashes 3 times.
or does not close properly.
The inner lighting
The temperature knob or sensor is
flashes 1 or 2 times.
defective.
The appliance is not level and stable.
The appliance is standing against
Unusual or loud noises
something.
The side of the
The condenser is located at the side
appliance is very warm
of the appliance.
During normal use of the cooling appliance, different types of noises can occur that do not have any effect on the correct
operation of the appliance.
Noises that can be heard during normal use of the appliance are caused by the operation of the thermostat, compressor
(activation), cooling system (shrinkage and expansion of the material under the influence of temperature differences and flow
of cooling liquid).
If the door must be installed the other way around, observe the instructions in section "Reversing the door opening".
RESOLVING FAILURES YOURSELF
Cause
Solution
Set the thermostat to a position between 1 and 7
to switch on the appliance.
Insert the plug into the socket.
Turn the thermostat to a different position.
Open the door less often and/or reduce the time
that the door remains open.
Temporarily set the thermostat to a lower position.
The appliance is intended for operation in an
ambient temperature indicated in the table with
technical data supplied with the appliance.
Change the location of the appliance according
to the instructions in the instruction manual.
Clean the opening of the defrost water drain
by means of the skewer.
Check that there is nothing between the door that
prevents it from closing and close the door.
Contact customer service.
Level the appliance with the adjustable feet.
Place the appliance in such a way that it is not
standing against anything.
It is normal for the exterior to become warm.
EN - 26
Publicité
