Accessories - Makita FS2200 Manuel D'instruction

Use of locator holder
1
2
009971
The locator can be temporarily held on the locator holder
during replacing bit or using without locator. To hold the
locator, position the trapezoidal holes of the locator on
the swells of the locator holder and push it in.
OPERATION
010105
Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool
as soon as the clutch cuts in. Then release the switch
trigger.
CAUTION:
When fitting the screw onto the point of the bit, be
•
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
Make sure that the bit is inserted straight in the
•
screw head, or the screw and/or bit may be
damaged.
Hold the tool only by the handle when performing
•
an operation. Do not touch the metal part.
1. Swells
2. Trapezoidal
holes
3. Locator holder
3
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.

ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Insert bits
•
Magnetic bit holder
•
Locator
•
6
or attachments
Only use accessory or
are