Accessories - Makita 6842 Manuel D'instructions

MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Replacing carbon brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes. (Fig. 16)
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps. (Fig. 17)
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.

ACCESSORIES

CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Phillips bit
• Drywall screw strips
• Extension handle
• Plastic carrying case
Noise
The typical A-weighted noise level determined according to
EN60745:
Model 6842, 6843
Sound pressure level (L
Sound power level (L
Uncertainty (K): 3 dB (A)
Model 6844
Sound pressure level (L
Sound power level (L
Uncertainty (K): 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K): 1.5 m/s
• The declared vibration emission value has been measured
in accordance with the standard test method and may be
used for comparing one tool with another.
• The declared vibration emission value may also be used in
a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the power tool
can differ from the declared emission value depending on
the ways in which the tool is used.
• Be sure to identify safety measures to protect the operator
that are based on an estimation of exposure in the actual
conditions of use (taking account of all parts of the operat-
ing cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita Corporation as the responsible manufacturer
declare that the following Makita machine(s):
Designation of Machine: Auto Feed Screwdriver
Model No./ Type: 6842, 6843, 6844
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following stan-
dards or standardised documents:
EN60745
The technical documentation is kept by our authorized repre-
sentative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, MK15 8JD, England
30.1.2009
Tomoyasu Kato
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, JAPAN
): 84 dB (A)
pA
): 95 dB (A)
WA
): 85 dB (A)
pA
): 96 dB (A)
WA
2
): 2.5 m/s or less
h
2
Director
ENG905-1
ENG900-1
ENG901-1
ENH101-14
7