Publicité
EN
Emergencies
• Always know the location of the nearest fire extinguisher and first aid kit. Know the location of the nearest telephone. Also know the phone numbers of the
nearest ambulance, doctor and fire department. This information will be invaluable in the case of an emergency.
Maintenance Safety
• Never lubricate components or attempt service on a running machine.
• Always allow the machine a proper amount of time to cool before servicing.
• Keep the machinery in running condition.
• Fix damage to the machine immediately and always replace broken parts.
• Dispose of hazardous waste properly. Examples of potentially hazardous waste are used motor oil.
• Fuel and fuel filters.
• Do not use food or plastic containers to dispose of hazardous waste.
OPERATION
Operating Principle
The following instructions were compiled to provide you information on how to obtain long and trouble free use of the unit. Periodic maintenance of this unit
is essential. Read the manual in its entirety and follow the instructions carefully. Failure to do so may injure yourself or a bystander.
Delivery Checks
Immediately upon taking delivery of your new equipment and before putting it into service:
• Read the handbook completely-it could save a great of unnecessary expense.
• Check the general condition of the equipment - has is been damaged during delivery?
• Check engine oil level.
• Check fuel levels.
Installing Blade
1. Be certain that the spark plug is disconnected or saw in unplugged.
2. Remove the blade shaft nut, and take off outside blade shaft flange.
3. Clean off any foreign particles on the clamping surfaces of flanges and on the mounting surface of the blade.
4. Place the blade on the blade shaft, lining up the offset drive pin in the blade with drive pin in the mounting collar (if the pin system is available on the
machine). If your blade has a directional rotational arrow, position arrow for down cut (diamond tail trailing for down cut).
5. Replace the outside blade shaft flange on the blade shaft. Drive pin on the inside collar must project through the drive in the blade and into the outside collar
(if the pin system is available on the machine).
6. Tighten the blade shaft nut securely against star washer and outside flange, using a wrench.
7. Reconnect the spark plug or (with switch "off ") plug in the electric supply cord.
Types of Cutting
• Cut speed depends entirely on using the correct blade for the material to be cut. Wet or dry, diamond blades of various specifications are available for cutting
concrete or asphalt.
• Before Starting / Cold Start / Hot Start / To Start Cutting.
Before Starting
1. Use correct blade for cutting conditions.
2. Ensure arbors and flanges are clean and undamaged .
3. Mount blade and tighten securely using wrench.
4. When wet cutting, check water jets for adequate flow.
5. Align pointer with cutter blade.
Caution – Set unit up in an open area. Avoid close proximity to structures or other equipment. Failure to do so may cause inadvertent injury to operator or
other persons in the area.
4
WWW.NIKOLAOUTOOLS.GR
Publicité
