Publicité
EN
• Do not smoke around or near the machine. Fire or explosion could result from fuel vapors, or if fuel is spilled on a hot engine.
• Never operate the cutter in an explosive atmosphere or near combustible materials. An explosion or fire could result causing severe bodily harm or even
death.
• Topping-off to the fuel filler port is dangerous, as it tends to spill fuel.
• Never use fuel as a cleaning agent.
• Always read, understand, and follow procedures in Operator's Manual before attempting to operate the equipment.
• Always be sure that the operator is familiar with the proper safety precautions.
• Stop the engine when leaving the cutter unattended.
• Block the unit when leaving or when using on a slope.
• Maintain this equipment in a safe operating condition at all times.
• Always stop the engine before servicing, adding fuel and oil.
• Never run engine without air filter. Severe engine damage may occur.
• Always service air cleaner frequently to prevent carburetor malfunction.
• Always store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children.
• Never operate this cutter in areas that contain combustible material or fumes. Explosions may result from errant sparks from the equipment.
Do not operate this equipment unless all guards and safety devices are attached in place.
Caution must be exercised while servicing this equipment. Rotating and moving parts can cause injury if contacted.
Keep all inexperienced and unauthorized people away from the equipment at all times.
Diamond Blade Safety
• Use appropriate steel centered diamond blades manufactured for use on concrete cutters.
• Always inspect diamond blades before each use. The blade should exhibit no cracks, dings, or flaws in the steel centered core and / or rim. Center(arbor) hole
must be undamaged and have the accurate model dimensions.
• Examine blade flanges for damage, excessive wear and cleanliness before mounting blade.
• Blade should fit snugly on the shaft and against the inside / outside blade flanges.
• Ensure that the blade is marked with and operating speed greater than the blade shaft speed of the cutter.
• Only cut the material that is specified by the diamond blade. Read the specifications of the diamond blade to ensure the proper tool has been matched to
the material being cut.
• Always keep blade guards in place. Exposure of the diamond blade must not exceed 180 degrees.
• Ensure that the diamond blade does not come into contact with ground or surface during transportation.
• Do not drop the diamond blade on ground or surface.
• The engine governor is designed to permit maximum engine speed in a no-load condition.
• Speeds that exceed this limit may cause the diamond blade to exceed the maximum safe allowable speed.
• Ensure that the blade is mounted for proper operating direction.
Cutter Transportation Safety
• Use the lifting bail and appropriate lifting equipment to ensure the safe movement of the cutter.
• Do not use the handle bars and /or front pointer as lifting points.
• Never tow the saw behind a vehicle.
• Ensure that both pointer bars are positioned appropriately to minimize their exposure during transportation.
• Safeguard against extreme cutter attitudes relative to lever. Engine tipped to extreme angles may cause oil to gravitate into the cylinder head making the
engine difficult to start.
• Never transport the cutter with the blade mounted.
3
WARNING
Unauthorized equipment modifications will void all warranties.
WWW.NIKOLAOUTOOLS.GR
Publicité
