Télécharger Imprimer la page

DeWalt POWERSHIFT DCPS660 Guide D'utilisation page 9

Dame vibrante

Publicité

is needed, the battery electrolyte is composed of a mixture of
liquid organic carbonates and lithium salts.
• Contents of opened battery cells may cause respiratory
irritation. Provide fresh air. If symptoms persist, seek
medical attention.
• Battery liquid may be flammable if exposed to spark
or flame.
• Never attempt to open the battery pack for any reason.
If the battery pack case is cracked or damaged, do not
insert into the charger or tool. Do not crush, drop or damage
the battery pack. Do not use a battery pack or charger that has
received a sharp blow, been dropped, run over or damaged
in any way (e.g., pierced with a nail, hit with a hammer).
Contact your D
WALT service center or distributor for returning
e
damaged battery packs.
• Do not use a battery pack or tool that is damaged
or modified. Damaged or modified batteries may exhibit
unpredictable behavior resulting in fire, explosion or risk
of injury.
• Do not modify or attempt to repair the battery pack
except as indicated in the instructions for use and care.
• Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact occurs, flush with
water. If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritations or burns.
• When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys, nails,
screws or other small metal objects, that can make a
connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
Storage Recommendations
The best storage place is one that is cool and dry, away
from direct sunlight and excess heat or cold. Store the fully
charged battery pack out of the charger or tool for optimal
storage life.
Battery Pack Cleaning Instructions
Dirt and grease may be removed from the exterior of the
battery pack using a cloth or soft non‑metallic brush. Do not
use water or any cleaning solutions.
Fuel Gauge Battery Packs (Fig. B)
Some battery packs include a fuel gauge. When the fuel
gauge button is pressed and held, the LED lights will
indicate the approximate level of charge remaining. This
does not indicate tool functionality and is subject to
variation based on product components, temperature, and
end‑user application.
Transportation

WARNING: Fire hazard. Do not store, carry, or
transport the battery pack so that metal objects can
contact exposed battery terminals. For example, do not
place the battery pack in aprons, pockets, tool boxes, product
kit boxes, drawers, etc., with loose nails, screws, keys, coins,
hand tools, etc. When transporting individual battery packs,
make sure that the battery terminals are protected and well
insulated from materials that could contact them and cause a
short circuit. NOTE: Li‑ion battery packs should not be put in
checked baggage on airplanes and must be properly protected
from short circuits if they are in carry‑on baggage.
shipping the D
WALT POWERshiFT® Battery Pack
e
Your D
WALT POWERSHIFT® battery pack of 600 Wh or less
e
has a shipping card that should be used when shipping
POWERSHIFT® batteries.
Attach the card to the battery pack to ready it for shipping.
This converts the battery pack to three separate batteries.
The three batteries have the Watt hour rating labeled
"Shipping" on the battery pack for US ground shipments.
If shipping without the card, the pack is one battery at the
Watt hour rating labeled "Use."
Example battery pack label:
USE: 554 Wh SHIPPING: 3 x 184.5 Wh
In this example, the battery pack is three batteries with
184.5 Watt hours each when using the card. Otherwise, the
battery pack is one battery with 554 Watt hours.
Battery Recycling
It is important to recycle lithium ion batteries at end of life as
they contain valuable materials that can be reused for new
purposes. Do not discard lithium ion batteries in the trash
as they can be crushed and start a fire during processing.
The batteries that are supplied with this equipment are
considered "High Energy Batteries" which mean that have
an energy greater than 300 Wh and need to be recycled in
a different a program than other lower energy rechargeable
battery packs. Please see the following website for more
information regarding battery recycling: dewalt.com/
high‑energy‑battery‑info.
IMPORTANT SAFETY INSTRUCTIONS FOR ALL
BATTERY CHARGERS

WARNING: Read all safety warnings, instructions,
and cautionary markings for the battery charger,
battery pack, and product. Failure to follow the warnings
and instructions may result in electric shock, fire and/or
serious injury.
• SAVE THESE INSTRUCTIONS ‑ This manual contains
important safety and operating instructions for D
battery chargers.
• Before using battery charger, read all instructions and
cautionary markings on battery charger, battery, and
product using the battery.
• To reduce risk of injury, charge only D
DCBPS‑series Li‑ion batteries. Other types of batteries may
burst causing personal injury and damage.
• Do not expose the charger to rain or snow.
• Do not allow water or any liquid to enter charger.
• Pull by the plug rather than the cord when
disconnecting the charger. This will reduce the risk of
damage to the electric plug and cord.
• Make sure that the cord is located so that it will not
be stepped on, tripped over or otherwise subjected to
damage or stress.
• Do not use an extension cord or power strip unless
it is absolutely necessary. Use of improper extension cord
English
WALT
e
WALT
e
7

Publicité

loading