Publicité
GB
• Symbols appearing on your device may
not be removed or covered. Signs on the
device that are no longer legible must be
replaced immediately.
Read and strictly observe the in-
structions for use before using the
product for the first time.
Important instructions for the
installation
Note: Expert knowledge from the
most different specialist areas are
required for the installation, hence
only the qualified, authorized per-
sonnel may install the device.
• It is recommended to install the device at
least 230 cm above the floor.
• Use only approved components to install
exhaust pipes.
• Install exhaust pipes in a such way that a
flow of condensed water into the device is
not possible.
• While drilling the wall pay attention to
existing cables and pipes in the wall.
• Please note minimum diameter of the
exhaust pipe (► Technical data – p. 32).
• Keep the exhaust pipes as short as pos-
sible.
• Install exhaust pipes in a vent stack in
flow direction.
Your product at a glance
Scope of delivery
• Built-in fan
• Fixing material
• Instructions for use
30
Mounting
Note: The unit with a protection rat-
ing against access to hazardous
parts and water ingress IP24 is
allowed to be installed in zone 2
according to IEC 60364-7-701:2019.
► Important instructions for the installation –
p. 30
► Assembly – p. 2
► P. 3, item 3
1. housing;
2. holes for power supply cable;
3. terminal block;
4. holes for fan mounting.
– Drill borehole for fan. Borehole diame-
ter = 100 mm
– Mark boreholes in the wall.
– Drill boreholes for fastening screws.
Borehole diameter = 5 mm
– Insert dowels.
– Tighten device frame.
– Lay electrical cable and pierce cable
sealing Allowable electrical cable:
► Technical data – p. 32
– Use cable sealing in device frame.
– Unscrew and remove the device cover.
– Connect the product to the power supply
(► Electrical connection – p. 31).
– Tighten the cable securing plate with
screws
– Attach device cover and fix it with screw.
– Cover fastening screws with plugs.
– WARNING! The power cable may only be
laid through the hole in the casing pro-
vided by the manufacturer. Laying the
Publicité
