Publicité
Brief operating instructions
11 Setup and transport
Danger of injury due to the device
falling down or tipping over.
Before transport, disconnect the mains
plug.
Carry the device using the transpor-
tation belt and keep it in a horizontal
position.
Do not use a fork-lift truck or similar de-
vice to lift the machine by its housing
or transportation belt.
The machine must be set up only on
firm, level and dry surfaces. The maxi-
mum admissible angle of inclination
for setting up is 10°.
Therefore, always ensure that the cool-
ing air openings are always uncovered.
– Do not set up the device directly by a wall.
– Do not cover any cooling air openings.
The device may overheat and be damaged.
Cooling air openings are located on the
– front of the housing
– rear of the housing
01.22
12 Brief operating instructions
 Position the protective gas bottle near the sys-
tem and protect it against falling over.
 Remove the screw cap from the inert gas cylin-
der and open the valve briefly (blow-out).
 Connect the pressure reducer to the inert gas
cylinder.
 Connect the insert gas hose from the unit to the
pressure reducer and open the cylinder valve.
 Connect the work piece line to the Pluspol 3
connection socket.
 Connect the TIG torch to the socket of the neg-
ative terminal 6.
 Insert the control plug of the TIG torch into
Socket 4.
 Connect the gas pipe of the TIG torch to Gas
connection 5.
 Connect the mains or battery cable.
 Switch the machine on by pressing the On/Off
button 28 for 2 sec.
 Set the desired welding current using rotary
knob 19.
9 The machine is now ready for welding.
909.4039.9-05
- 31 -
Publicité
