Publicité
General regulation of use
Please heed the safety regulations which apply
to your country. Subject to change.
4
Accident prevention inspection
(UVV)
Operators of commercially-operated welding sys-
tems are obliged to have regular safety inspec-
tions of the equipment carried out in accordance
with EN 60974-4. Lorch recommends inspections
at 12 month intervals.
A safety inspection must also be carried out if
modifications or repairs have been made to the
system.
Improper accident prevention inspec-
tions can destroy the system. For more
information on accident prevention
inspections of welding systems, please
contact your authorised Lorch service
centre.
5
Ambient conditions
Temperature range of ambient air:
In operation: -20 °C ... +40 °C (-4 °F to +104 °F)
Transport
and storage: -25 °C ... +55 °C (-13 °F to +131 °F)
Relative humidity:
up to 50 % at 40 °C (104 °F)
up to 90 % at 20 °C (68 °F)
Operation, storage and transport may
only be carried out within the ranges
indicated! Usage outside of this range
is considered to be not as intended.
The manufacturer is not liable for dam-
ages cause by misuse.
Ambient air must be free of dust, acids, corrosive
gases or other damaging substances!
01.22
6
General regulation of use
This machine is intended for use in the com-
mercial and industrial sector. It is portable and
suitable for operation using the mains supply, a
power generator or for operation with a battery
(optional).
The machine is intended for electrode welding.
Together with a TIG welding torch, the machine
can be used for TIG welding with direct current of
– unalloyed steels, low and high-alloy steels,
– copper and its alloys,
– nickel and its alloys,
– special metals like titanium, zirconium, tan-
talum.
The device is not intended for TIG welding of alu-
minium and magnesium with alternating current.
The supply of MicorTIG 200 Accu-ready with
MobilePower 1 is in accordance with DIN VDE
0100-410 / IEC 60364-4-41:2005-12, Section 413
and the protective measure: electrical separation.
The transport and use in areas with increased
electrical risk such as containers and narrow,
enclosed spaces is therefore permitted according
to BGV D1 (VBG15, welding, cutting and related
methods Section 29, Section 45) and BGR500
(Operation of work tools, Chapter 2.26), BGR117
(Working in containers and narrow spaces, Chap-
ter 4.7), BRG126 (Working in enclosed spaces
of waste-water plants, Chapter 4.8) as well as
BGI594 (Use of electrical tools under increased
electrical risk, Chapter 3.2).
909.4039.9-05
- 29 -
Publicité
