Domo DO7296S Mode D'emploi page 66

Plan cleaning (smart cleaning)

The vacuum cleaner will move through the room and vacuum in an S-shaped motion.

HOME: return to the charging station for re-charging

If you wish to charge the vacuum cleaner during use, press the HOME button. The vacuum cleaner will

now automatically look for the charging station.

PLEASE NOTE: it is possible that the vacuum cleaner cannot find the charging station because there

are too many obstacles around the charging station. Make sure that the free area around the charging

station is as large as possible.

When the battery is almost empty, or when the appliance has finished its programme, the vacuum

cleaner will automatically return to the charging station if one has been installed. If no charging

station is installed, the vacuum cleaner enters standby mode.

Arrows

In standby mode, press this arrow to move the vacuum cleaner forwards.

For other settings, this button can be used to increase the value.

In standby mode, press this arrow to turn the vacuum cleaner 180 degrees.

For other settings, this button can be used to decrease the value.

In standby mode, press and hold this arrow to move the vacuum cleaner to the left.

For other settings, this button can be used to switch from minutes to hours.

In standby mode, press and hold this arrow to move the vacuum cleaner to the right.

For other settings, this button can be used to switch from hours to minutes.

Confirmation button/pause button

This button can be used to start automatic cleaning when the appliance is in standby mode. The

vacuum cleaner will plot its own path to vacuum the entire room, and will avoid walls, obstacles, and

stairs.

When the battery is almost empty, or when the appliance has finished its programme, the vacuum

cleaner will automatically return to the charging station if one has been installed. If no charging

station is installed, the vacuum cleaner will enter standby mode.

You can also make the appliance stop cleaning. To do this, press the on/off switch. Switch the

appliance off using the on/off switch on the side of the appliance.

Use this button to confirm your settings.

This button can also be used to pause the vacuum cleaner. If you press this button again, the appliance

will continue to complete its programme.

Suction level adjustment

Use this button to set the suction level. A symbol for the selected setting will be shown on the display.

Clock settings

Press this button to set the clock.

The hours on the display will flash. Set the hours by pressing the up or down arrows.

Then press the right arrow to set the minutes. The minutes on the display begin to flash. Set the

minutes by pressing the up or down arrows.

Press the confirmation button to confirm the time.

Wall-guided cleaning

Press this button to set a route where the vacuum cleaner cleans along walls and also cleans corners.

DO7296S