Publicité
·
When the battery is almost empty, or when the appliance has finished its programme, the vacuum
cleaner will automatically return to the charging station if one has been installed. If no charging
station is installed, the vacuum cleaner will enter standby mode.
·
You can also choose to charge the appliance sooner by pressing the HOME button on the remote
control.
·
When charging, the control button indicator light on the appliance will flash. Once the vacuum cleaner
is fully charged, the light will switch off.
CHARGING WITHOUT CHARGING STATION
1.
Plug the adapter into a socket and insert the adapter output
into the device.
2.
When charging, the control button indicator light on the
appliance will flash. Once the vacuum cleaner is fully charged,
the light will switch off.
PLEASE NOTE
·
Ensure that the on/off switch on the side of the appliance is on at all times, otherwise the appliance
will not be able to charge.
·
Ensure the adapter is plugged into a socket and connected to the charging station, otherwise the
vacuum cleaner will not be able to find the charging station.
USE
The robot vacuum maps the room using a laser beam and thus cleans the room most efficiently. In
addition, its sensors ensure it does not collide with anything. It is advisable to tidy up the room as best as
possible and remove as many obstacles as possible.
For optimal performance and the best cleaning results, it is best to follow these tips:
·
Remove loose objects, obstacles and small furniture from the ground.
·
Place chairs neatly around the table or raise them off the floor.
·
Remove objects and cables that could cause the robot to get stuck.
·
Remove objects lower than 18 mm.
·
Fold the tassels on the edges of the rugs inward to prevent the robot from getting stuck.
·
Roll up or remove dark-coloured, deep-pile rugs or rugs thicker than 18 mm, as this may cause
problems for the robot.
·
In most cases, anti-fall sensors will prevent the robot from falling and/or making steep descents.
However, these sensors are less effective when they are dirty or when the robot is moving on
carpeted, reflective or dark-coloured floors. Therefore, it is advisable to cordon off stairs and holes, set
them as a no-go zone, or set up a virtual wall in the app.
·
It is recommended that fireplaces and certain areas (e.g. ventilation floor grilles) where the robot
could be damaged be cordoned off, set as a no-go zone, or set up as a virtual wall in the app.
·
Do not walk near the working robot. The robot could recognise you as an obstacle and skip places
when vacuuming.
Turn the machine on with the on switch on the side of the appliance prior to use or
charging.
64
DO7296S
Publicité
