Publicité
Translation of the original instructions
Sensitivity setting :
«Short press: reduces sensitivity. Long press: anti-light interference mode. When working in a very bright environment, activate the anti-light interference
SENS
mode.
«+»: Short press: increases sensitivity. Long press: activates the automatic function. When the automatic sensitivity function is activated, the SENS field
displays «AUTO». The sensitivity numbers increase in turn from 0 to 8 and stop at the automatically set speed number.
Time to clear :
Delays the return to the clear state to protect against radiation at the end of the weld.
DELAY
«Short press: Decreases the time taken to return to the clear state. Long press: activates or deactivates the automatic function. When the automatic delay
function is activated, the DELAY zone displays «AUTO». The report numbers on the screen can be set from -9 to +9 .
«+»: Short press: Increases the time taken to return to the clear state.
PRECAUTIONS
- The mask can be used for all types of welding processes except oxyacetylene, laser and gas welding.
- An outer and inner protective shield must be fitted on both sides of the filter. The absence of a shield can cause irreversible damage and be a danger to your safety.
HEADBAND ADJUSTMENT
1
2
4
3
SERVICING / MAINTENANCE
- Best before date: There is no best before date for this product, but before each use the condition of your mask should be checked.
- The mask must not fall to the ground.
- Damage to the optoelectronic filter or its guard reduces vision and the level of protection. Replace damaged parts immediately.
- Do not use any tools to remove parts of the mask or filter, as this may cause damage that could result in injury or invalidate the guarantee.
REPLACEMENT OF THE EXTERNAL GUARD SCREEN (REF. 075580)
1
2
a
a
GYSMATIC 2.0 CL TRUE COLOR XXL
Light shade
2
Dark shade
Cut : 4-8 / Weld : 8-12
Filter dimensions
114.30 x 133.35 x 9 mm
Reaction time
0.08 ms
Power supply
Solar + batteries (CR2032 x 2)
Weight
550 gr
Field of view
100 x 93 mm + 124.7 x 65.6 mm (x2)
Field of application
MMA / TIG>2A / MIG / Grind
Warranty
2 years
Operating temperature
-5°C / + 55°C
Storage temperature
-10°C / + 60°C
The Ergolift+ headband is lightweight and ergonomic. Its design with 3 adjustable balance points offers greater
flexibility and comfort.
1. Headband adjustment
2. Headband slider (with 3 notches)
3. Lock washer adjustment
4. Longitudinal adjustment
1. Unclip the cover (1) by pulling slightly on the sides (a).
2. The outer cover (2) can be removed by placing a finger under the screen. When changing the
screen, remember to remove the protective film first. This film cannot be removed when the cover
is already in position in the mask.
Replace the outer safety screen (2) by inserting one side of the screen into either of the side slots,
then bend the screen just enough to allow it to slide into the opposite slot.
3. Re-clip the guard (1).
9
EN
Publicité
