Asko T608HX Mode D'emploi page 205

The heat pump fi lter has to be correctly placed into its slot. Otherwise, the heat exchanger installed inside
the dryer may be clogged.
Use a soft dry cloth to also clean the heat pump
5
fi lter housing and net.
Lower part of the hosing contains a strainer which
shall be cleaned thoroughly.
Clean the heat pump fi lter housing and net after
every 10 drying cycles or if necessary.
With automatic heat pump net fi lter cleaning (only
available in some models), a few drops of water may
drip on the fl oor after the fi lter is removed; therefore,
lay a cloth on the fl oor.
The dust and dirt in the metal fi ns of the heat
6
exchanger can be cleaned with a vacuum cleaner
and a soft brush attachment.
Without pressing, gently move the brush attachment
only in the direction of the metal fi ns from top to
bottom. Too much pressure can damage or bend the
metal fi ns of the heat exchanger.
We recommend you clean the heat exchanger at least
every twelve months.
Reassemble the foam fi lter and the fi lter housing.
7
Reinstall the inside cover and rotate the levers
8
clockwise to the vertical position.
Close the outer cover.
37