Publicité
3. a) Plug the Power Connector ©.
À
b) Install the Trim plate 60.
EE"
© Power Connector
4. After installation reconnect the
UN
negative (—) battery terminal.
|
dd Trim plate
To Remove the Unit
a) Remove the trim plate with a screwdriver as
shown in the figure.
Trim plate
b) Pull out the unit while pushing two lock levers using Screwdriver in the following order.(Fig.1 : 2)
c) Remove the unit pulling with both hands.(Fig.3)
|
Lock Lever
CQ-DPG655/605EUC
Publicité
