Publicité
O Connect All Leads
Now that you have identified all the wires in the
vehicle, you're ready to begin connecting them to
the stereo unit wires. The connection diagram on
Page 28 show the proper connections and color
coding of the leads.
We strongly recommend
that you test the unit
before making a final installation.
You can set the unit on the floor and make
temporary connections to test the unit.
Use
electrical tape to cover all exposed wires.
Important: Connect the red power lead last, after
you
have
made
and
insulated
all other
connections.
Ground
Connect the black ground lead of the power
connector to the metal vehicle chassis.
Speakers
Connect the speaker wires.
See the wiring
diagram for the proper hookups.
Follow the
diagram carefully to avoid damaging the speakers
and the stereo unit.
The speakers used must be able to handle more
than 50 watts (for CQ-DPG605EUC; 40 watts) of
audio power. If using an optional audio power, the
speakers should be able to handle the maximum
amplifier output power. Speakers with low input
ratings can be damaged.
Speaker impedance should measure 4 - 8 ohms,
which is typically marked on most speakers.
Lower or higher impedance speakers will affect :
output and can cause both speaker and stereo
unit damage.
Caution: Never ground the speaker cords. For
example, do not use a chassis ground system or
a three-wire speaker common
system.
Each
speaker must be connected separately using
parallel insulated wires. If in doubt about how
your car's speakers are wired, please consult with
your nearest professional installer.
Motor Antenna
Connect the vehicle motor antenna lead to the
blue motor antenna relay control lead.
Battery
Connect the yellow battery lead to the correct
radio wire or to the battery fuse port on the fuse
block.
Antenna
Connect the antenna by plugging the antenna
lead into the antenna receptacle.
Equipment
Connect
any
optional
equipment
such
as
amplifier, according to the instructions furnished
with the equipment. Keep about 12 inches (30
cm)
of
distance
between
the
speaker
cords/amplifier unit and the antenna/antenna
extension
cord.
Read
the
operating
and
installation instructions for any equipment you will
connect to this unit.
Power
Connect the red power lead to the correct vehicle
radio wire or to the appropriate fuse port on the
fuse block.
If the stereo unit functions properly with all these
connections
made, disconnect the wires and
proceed to the final installation.
O Final Installation
Lead Connections
Connect
ali wires,
making
sure that each
connection is insulated and secure. Bundle all
loose wires and fasten them with tape so they
won't fall down later. Now insert the stereo unit
into the mounting collar.
Congratulations!
After making a few final checks,
you're ready to enjoy your new auto stereo
system.
J Final Checks
1. Make
sure
that
all wires
are
properly
connected and insulated.
2. Make sure that the stereo unit is securely held
in the mounting collar.
3. Tum on the ignition to check the unit for proper
operation.
If you have difficulties, consult your nearest
authorized professional instailer for assistance.
CQ-DPG655/605EUC
23
E
N
G
L
|
S
H
medo ~
Publicité
