Publicité
Installation Guide
ÁN WARNING
The installation information is designed for experienced installers and is not
intended for non-technical individuals. It does not contain nermnas or cautions of
potential dangers in attempting to install this product.
Any attempt to install this product in a motor vehicle by anyone other than
qualified installer could cause damage to the electrical system and could result in
serious personal injury or death.
O Overview
O Installation Hardware
No.)
tem
| Diagram |aty
g Mounting Collar
EN
(2) | Hex. Nut (5 mm)
a Mounting Bolt (5 mm)
Q Power Connector
bs Removable Face Plate
Soft Case
Remote Control Unit
T
fa
This
equipment
should
be installed
by a
professional.
However, if you ptan to install this
unit yourself, your first step is to decide where to
install it. The instructions in these pages will
guide you through the remaining steps: (Please
refer to "WARNING" statement above).
¢ Identify and label the vehicle wires
+ Connect the vehicle wires to the wires of the
power connector
*
Install the unit in the dash
e Check the operation of the unit
if you do encounter problems, please consult
your nearest professional installer.
Caution: This unit will operate with a 12 volt DC
negative ground auto battery system only. Do not
attempt to use it in any other system. Doing so
could cause serious damage.
Before you begin installation, look for the
following items included in the pacung with your
unit,
¢ Warranty Card .... Fill this out promptly
+ PASC, Panasonic (in Canada) Servicenter
- Directory ..... Keep for future reference in case
the unit needs servicing
e Installation Hardware ..... Needed for in-dash
installation
CQ-DPG655/605EUC
=)
Publicité
