Etherma ET-DUO-PLUS Instructions De Montage Et D'utilisation page 24

3 . U S I N G T H E I N E R T I A R A D I A T O R , T O U C H R A N G E
3.5 AUTOMATIC MODE (continued)
How to select and carry out custom programming.
a) Press the 'OK/mode' button.
b) Select the auto mode by pressing the
(Automatic Mode) is displayed and press the 'OK/mode' but-
ton to confirm.
c) The display will now show the set temperature together
with a red dot that indicates the unit is working in automatic
mode. If the unit has been programmed previously then it
may show .
d) Press the 'OK/mode' button for a few seconds until
(Configure Time) is displayed.
e) Press the button and then press the 'OK/mode' button on
(Select Day).
f) Press and buttons to select the day you wish to change
the on/off times and then press the 'OK/mode' button.
g) The display now shows
ding on how it was previously programmed. The
tes the time in hours, i.e.
so on.
h) By using the and
(ECO) or (ON) for that time period. Once selected
press the 'OK/mode' button to move to the next time period.
i) Repeat step h) until you go through all the 24 hours. The dis-
play will now show
the next day to program. Press the 'OK/mode' button and
continue from step f) if you wish to program each day indi-
vidually. Alternatively you can copy one day to the next by
following steps in section 3.6 COPY FUNCTION step b).
24
button until
or or
= 12:00 am, = 01:00 am and
buttons you can select
allowing you to select
3.6 COPY FUNCTION
This function enables you to copy a previously programmed day
to any other day. i. e. day1 to day2 or day1 to day5, etc.
To copy the setting of one day into another, do as follows:
a) Press the 'OK/mode' button for a few seconds until
b) Press button until
the 'OK/mode' button.
c) Press button to select the day you wish to copy and press
the 'OK/mode' button.
d) The display will now show
on which day you selected. The first number is the day you
are copying from, the second number is the day you are co-
pying to.
e) By Pressing
to copy to. Once happy press the 'OK/mode' button to copy.
depen- f) You are now taken back to
indica- can press the 'OK/mode' button to copy another day (repeat
from step c)) or exit by pressing the '
(OFF), Note: If (Automatic Mode) is selected the heater cannot be
turned off. To turn off the device, press the 'OK/mode' button and
use and buttons to select
the 'OK/mode' button. You can now turn off the device using the
' /esc' button.
3.7 PILOT WIRING MODE
This mode is only enabled for the French market under GIFAN
standards.
(Configure Time) is displayed.
displayed and press
,
button you can now change the day you want
/esc' button.
(Manual Mode) then press
, etc. depending
menu where you