Etherma ET-DUO-PLUS Instructions De Montage Et D'utilisation page 22

3 . U S I N G T H E I N E R T I A R A D I A T O R , T O U C H R A N G E
1. "POWER /esc" button: turn on and off the device / al-
lows moving back from any menu.
2. "OK/mode" button: To access main menu and select or
confirm the desired option.
3. "UP/DOWN" arrows
and navigate through the different options of the menus.
4. DISPLAY: shows the different options and desired values.
5. RED DOT: if flashing, the device is working in PILOT WI-
RING mode, if not, then it is working in automatic as per
the set programming.
3.1 STARTING THE DEVICE
After connecting the power cable to a mains power outlet, click
the switch on the right. The display starts, shows a welcome
message, and shows
wer button) and the set temperature appears on the screen.
3.2 SETTING DATE AND TIME
a) Press the 'OK/mode' button for a few seconds.
b) The display shows
If not, press until you see it and press the 'OK/mode'
button.
c) The display shows H (Hours), using the
adjust the hours to the current time and press the 'OK/
mode' button.
22
: allows you to set the values
. To start the device, press
(Configure Time).
and
d) The display now shows N (Minutes), using the
buttons adjust the minutes to the current time and press
the 'OK/mode' button.
e) The display now shows DAY.1, use the
to select the current day of the week (i.e. DAY.1 is Monday,
DAY.2 is Tuesday, etc.) and then press the 'OK/mode' but-
ton.
f) The display now shows
Time) again. Press the '
The date and time are now set. Your device is now working!
3.3 MANUAL MODE
In this mode, the device works using factory settings. All you
have to do is press
The set temperature can be modified from 15 ºC to 28 ºC in
intervals of 0.5 ºC.
How to select the manual mode.
a) Press the 'OK/mode' button.
b) Select the mode by pressing
(Manual Mode) is displayed and press the 'OK/mode' but-
ton to confirm.
c) Now select the desired temperature by pressing
buttons.
The heater will now operate and cycle on and off up to the desi-
(Po-
red temperature.
Note: The FROST setting automatically activates to prevent
temperatures from going below 7 ºC. To activate this setting
simply press the '
the display should show OFF.
buttons
and
/esc' button.
to select the desired temperature.
or buttons until
/esc' (Power button) to turn the heater off,
and
buttons
(Configure
and