Publicité
34. Maintenance and care
Before any maintenance and cleaning work
•
Switch off the engine
•
Wait until the engine has come to a standstill
•
Disconnect spark plug connector (except when adjusting the idle speed)
Beware of rotating parts! Danger!
Due to the risk of fire, do not carry out maintenance work in the vicinity of open flame.
Maintenance and cleaning work not described in this chapter may only be carried out by customer
service.
Safety devices that have been removed for maintenance and cleaning must be properly checked and
reattached before use.
Only use original parts. Other parts may cause unforeseeable damage or pose a danger to the user.
Maintenance
Wear gloves to avoid injury.
To ensure a long and reliable use of the device, carry out the following maintenance work
regularly.
Check the device for obvious defects such as
•
loose fastenings
•
worn or damaged components
•
Tank cap and fuel lines for their tightness
Check the device for wear after each use.
Clean or replace the air filter
Clean the air filter every 25 hours of operation or every 3 months to remove dust and dirt and to
prevent:
-performance losses,
-startup problems,
-too high fuel consumption
Clean the air filter approx. every 8 operating hours, or even more often in particularly dusty
conditions.
1. Set the starting lever (choke)
2. Remove the air filter cover 5 by opening the wing nut
3. Remove the foam air filter
4. Wash the air filter in lukewarm soapy water
Do not blow out the dirt, there is a danger of eye injuries!
5. Clean the inside of the air filter with a brush.
6. Allow the air filter to dry thoroughly and replace it.
7. Replace the air filter cover
Manual_FX-LBS126P_Int24_Rev13
to open, so that no dirt gets into the carburettor.
46
Publicité
