Publicité
31. Commissioning - refuelling, 2-stroke engine oil
The device is not delivered filled with fuel mixture.
Fill the device as described in this chapter under "Refuelling".
The device is operated with a 40:1 mixture of normal petrol (unleaded) and two-stroke
engine
oil.
When handling petrol, increased attention is required. Avoid smoking and naked flames at
all costs because of the danger of explosion.
Gasoline:
Octane number at least 91 RON, lead free
•
Do not fill with leaded petrol, diesel or other non-approved fuels.
•
Do not use petrol with an octane number lower than 91 RON. This can lead to engine damage
due to increased engine temperatures.
•
If you work continuously in the higher speed range, use petrol with a higher octane rating.
•
For environmental reasons, the use of unleaded petrol is recommended. The use of E10 fuels is
not permitted.
2-stroke engine oil
Do not use four-stroke or two-stroke oils for water-cooled outboard engines, or ready-mixed
fuel from petrol stations.
Mixing ratio 40:1
Gasoline
1 litre
2 litres
•
Ensure that the oil quantity is measured exactly, as a small deviation in the oil quantity has a
strong effect on the mixing ratio for small quantities.
•
Do not change the mixing ratio, as this will result in increased combustion residues, increased
fuel consumption and reduced performance, or damage to the engine.
Mix the petrol and oil in a clean, petrol approved and marked container with overfill protection.
1. First fill in half of the petrol to be mixed
2. Then fill in the entire quantity of oil.
3. Shake the mixture.
4. Fill in the rest of the fuel.
Manual_FX-LBS126P_Int24_Rev13
Two-stroke engine oil
(40:1)
0.025 litres
0.050 litres
42
Two-stroke engine oil
Gasoline
5 litres
0,125 litres
10 litres
0.250 litres
(40:1)
Publicité
