Publicité
EN
PAIRING
CONNECT TO A BLUETOOTH
The first time you power your headphones ON they will enter pairing
mode. Open the Bluetooth
Manually activate pairing mode by holding the Power/Pairing button for 4
seconds until the indicator light pulses and the pairing tone is heard. This
can be done when the headphones are ON or OFF. Access the Bluetooth
menu on your device and select MW75 Neuro. Hold the button again to
cancel pairing mode.
LEFT
MULTIPOINT
Up to two devices can be connected to the MW75 Neuro at one time. When
using multipoint, audio content will automatically switch between devices
and phone calls will interrupt active content.
1. Enter pairing mode and connect to device 1
2. Enter pairing mode again and device 1 will disconnect.
3. Connect to device 2 and turn headphones OFF.
4. Turn headphones ON and headphones will automatically connect to
device 1 and 2 simultaneously.
5. Pause one device and play from the other to swap headphone
connection.
DEVICE
®
®
menu on your device and select MW75 Neuro.
POWER/PAIRING INDICATOR LIGHT
POWER/ PAIRING BUTTON
7
Publicité
