Publicité
Fig. 6 Abb. 6
Fig. 7 Abb. 7
Connecting the Units
Note:
.
This unit is for vehicles with a 12-volt
battery and negative grounding. Before
installing it in a recreational vehicle,
truck, or bus, check the battery voltage.
To avoid shorts in the electrical system,
be sure to disconnect the battery © cable
before beginning installation.
After completing installation and wiring,
double check that there are no mistakes.
Re-install any parts removed from the
car during installation, then connect the
battery negative terminal.
Refer to the owner's manual for details
on connecting the various cords of the
power amp and other units, them make
connections correctly.
Secure the wiring with cable clamps or
adhesive tape. To protect the wiring,
wrap adhesive tape around them where
they lie against metal parts.
Route and secure all wiring so it cannot
touch any moving parts, such as the gear
shift, handbrake, and seat rails. Do not
route wiring in places that get hot, such
as near the heater outlet. If the insulation
of the wiring melts or gets torn, there is a
danger of the wiring short-circuiting to
the vehicle body.
Don't pass the orange lead through a
hole into the engine compartment to
connect to the battery. This will damage
the lead insulation and cause a very dan-
gerous short.
Do not shorten any leads. If you do, the
protection circuit may fail to work when
it should.
Never feed power to other equipment by
cutting the irsulation of the power sup-
ply lead of the unit and tapping into the
lead. The current capacity of the lead will
be exceeded, causing over heating.
When replacing fuses, be sure to use
only fuses of the rating prescribed on the
fuse holder.
Since a unique BPTL circuit is employed,
never wire so the speaker leads are
directly grounded or the left and right
speaker © leads are common.
Speakers connected to this unit must be
high-power type possessing maximum
input of at least 30 W and impedance of
4 to 8 ohms. Connecting speakers with
output and/or impedance values other
than those noted here can damage the
speakers.
Publicité
