Tetra AquaArt Explorer Line 30 l Mode D'emploi page 9

 Route the mains cables for the filter and
heating element upwards out of the aquar-
ium.
 Follow the attached instructions for the filter
box, filter and heating element to complete
the remainder of the installation work.
Installing additional electrical de-
vices
You can install additional electrical devices (for
example heating elements) in the aquarium if
required.
 Pull out the plugs of all the electrical devices
installed in the aquarium.
 Install electrical devices as described in the
relevant instructions for use and other in-
structions supplied by the manufacturer.
 Carefully remove the covers from the re-
quired cable guides and optional positions in
the aquarium lid (Figures B and C).
 Proceed as described in the previous section.
Connecting and starting
 Start the electrical devices installed in the
aquarium as described in the attached in-
structions.
LED luminaire
 Fit the plug into the socket.
There are two switch positions for selecting the
colour of the lighting:
• Day lighting: The lighting unit emits daylight
white light.
• Night lighting: The lighting unit emits blue
light. This creates an attractive moonlight ef-
fect.
• Ideally the light should be on for 8 to 12
hours per day.
• Using a timer the day lighting could be
turned on and off automatically.
English translation of the original German
Cleaning
 Pull out the plugs of all the electrical devices
installed in the aquarium.
 Empty the tank.
ATTENTION!
Incorrect cleaning may damage the aquar-
ium or poison the tank contents.
 Never use any hard, pointed or sharp
objects for cleaning purposes.
 Use soft cloths or sponges.
 Use only clean water or special aquar-
ium cleaning products for cleaning pur-
poses. These are available from your
stockist.
 Particularly the corners of the tank
must be cleaned carefully to prevent
damage to the glued joints of the glass
walls.
 Clean the aquarium carefully.
Maintenance
 Pull out the plugs of all the electrical devices
installed in the aquarium.
CAUTION
Shards of glass can cause cuts.
 Ensure that you do not break the tank.
 Do not touch the shards of glass if the
tank breaks.
 Wear gloves.
 Remove all shards of glass carefully.
 Carry out maintenance work on the electrical
devices in the aquarium as described in the
attached instructions.
instructions
9