Tetra AquaArt Explorer Line 30 l Mode D'emploi page 7

Unpacking and installation
There must be properly installed and earthed
sockets (230 V ~ 50 Hz) near the installation site
of the aquarium for the electrical devices in it.
 Pull out the plugs of all the electrical devices
installed in the aquarium.
CAUTION
Shards of glass can cause cuts.
 Ensure that you do not break the tank.
 Do not touch the shards of glass if the
tank breaks.
 Wear gloves.
 Remove all shards of glass carefully.
ATTENTION!
The aquarium lid may be damaged and
the glass broken if you unpack it incor-
rectly.
 Lift the aquarium by the frame only.
 Always lift and transport the aquarium
with another person.
 Open the packaging.
 Carefully lift the aquarium out of the packag-
ing.
ATTENTION!
The aquarium may be damaged if you se-
lect an unsuitable position for it.
 Ensure that the position is flat, horizon-
tal and waterproof.
 Ensure that the position for it is capable
of taking the weight of the unit.
The load capacity of the installation position
must be high enough to support three times
the filled weight of the aquarium. Information
about the gross weight is available in the sec-
tion entitled Technical data starting on page 10.
English translation of the original German
 Place the aquarium with the frame at the
bottom in the required position.
 Take out all the parts that are in the tank.
 Clean any impurities out of the tank.
 Never use any hard, pointed or sharp objects
for cleaning purposes.
 Use soft cloths or sponges.
 Add warm tap water at a temperature of ap-
prox. 25 °C to the tank.
 Check the tank for leaks.
 If the aquarium is leaking, empty it and re-
turn the tank to your stockist for a replace-
ment.
Installing the LED luminaire
(Figures A and B)
 Pull out the plugs of all the electrical devices
installed in the aquarium.
 Install the LED luminaire in the position pro-
vided for it (Figure A).
 Do not overtighten the securing screws for
the LED luminaire in order to avoid damaging
the aquarium wall.
Installing the filter in the Explorer
Line 30 l
The AquaArt Explorer Line 30 l Crayfish and the
AquaArt Explorer Line 30 l Goldfish are supplied
with the EasyCrystal Filter 250.
 Pull out the plugs of all the electrical devices
installed in the aquarium.
 Remove the aquarium lid.
 Select a position to install the filter on the in-
side of the tank which is not curved.
 Ensure that you keep the filter the required
distances from the base and from equipment
in the aquarium.
The required distances are listed in the at-
tached instructions for the filter.
instructions
7