Mounting Of Drive Battery - Reely MISSION Notice D'emploi

c) Mounting of drive battery
To install the battery pull off both retaining clips (1) and lift
the mounting brace (2) out towards the top.
Now place the rechargeable battery into the chassis and
replace the mounting brace. The securing of the mounting
brace is then taken on by the two retaining clips again.
The battery recess is designed for many different types of
rechargeable batteries.
Next to in-inline soldered racing packs (see picture), battery
packs with cells that are aligned in parallel can also be used.
In this case the mounting brace has to be put in with the top
side pointing downward.
Even 7-cell racing packs can be used when the mounting
brace (3) on the back is taken off and the back chassis drill-
ing (4) is put back in.
Warning!
The rechargeable battery pack must not yet be connected to the cruise control/receiver.
30
2 3
Figure 2
Figure 3