Publicité
GB
MT
Assembling the motor head
(Fig. A)
1. Place the motor head (1) on the direct
container (6). The On/Off switch (3)
points to the suction connector (5).
2. Lock the snap locks (8) on the dirt con-
tainer (6).
Assembly
State on delivery
• Motor head (pre-mounted)
• Textile filter (pre-mounted)
• 5 × Foot (with castor and accessories
holder) (not assembled).
Assembling the feet (Fig. A)
1. Remove the motor head (1).
2. Place the dirt container (6) on a solid
surface with the bottom facing up.
3. Place the feet (7) in the holders on the
bottom of the dirt container.
You will hear the feet click into place.
4. Mount the motor head (1).
Attaching and removing the
filter and filter bag
Overview
The appliance has the following filters and
bags:
• Textile filter (16)
• Dry vacuuming
• Use an additional paper filter bag
so that the textile filter does not clog
up so quickly.
• Foam filter (15)
• Wet vacuuming
• Paper filter bag (17)
• Dry vacuuming
• Fine dust filter bag
• Vacuuming fine dust
• available as accessories
Removing the textile filter (Fig. C)
1. Remove the motor head (1).
26
Place the motor head (1) with the top
facing downward.
2. Remove the textile filer (16).
Installing the textile filter (Fig. C)
1. Remove the motor head (1).
Place the motor head (1) with the top
facing downward.
2. If necessary, remove the foam filter
(15).
3. Pull the textile filter (16) fully over the
filter basket (21).
4. Mount the motor head.
Installing the filter bag (Fig. C)
These instructions apply for the paper fil-
ter bag (17) and the fine dust filter bag
(available as accessories).
1. Remove the motor head (1).
Place the motor head (1) with the top
facing downward.
2. Pull the filter bag (17) inside the dirt
container (6) over the suction connec-
tion (5). The sealing ring (23) on the
filter bag opening must fully surround
the connector (24) on the suction con-
nection.
3. Mount the motor head.
Removing the filter bag (Fig. C)
1. Remove the motor head (1).
Place the motor head (1) with the top
facing downward.
2. You can remove the filter bag (17).
3. Mount the motor head.
Removing the foam filter (Fig. B)
1. Remove the motor head (1).
Place the motor head (1) with the top
facing downward.
2. Carefully remove the foam filter (15).
Installing the foam filter (Fig. B)
Only insert a dry filter.
1. Remove the motor head (1).
Publicité
